Combining the power of the Switch-Pros Module with the organization of Blue Sea Systems gives you everything you need to organize and maintain your electrical accessories like the professionals.
Take all the guess work out of wiring in a new accessory. The Switch-Pros PowerTray employs a dedicated grounding busbar and an isolated-circuit terminal block to make wiring up new products a breeze. No more fiddling around with excess wires or scrambling to find a place to ground your accessories negative wire. We've been there and done that and have learned from our struggles.
Now with the Switch-Pros PowerTray system installed, wiring in a new accessory (like a light bar or fridge outlet) is as easy as taking the positive and negative wires from your new accessory and running them up through the center wire slot and crimping on two small ring terminals. Then simply attach the positive wire to one of the isolated circuits on the Blue Seas Terminal Block and the negative wire to the common ground of the Blue Seas Busbar. That's it, you're done!
Whether you're a weekend warrior or touring full time, the Switch-Pros PowerTray System has you covered.
The Switch-Pros PowerTray System also uses a Blue Sea 5025 fuse block which gives you the added ability to wire in accessories that would be inconvenient to power though a Switch-Pros. For example, under hood lights and cargo lights can now have an external switch located right where you want it, no more running back into the cab to turn them on. An addition fuse block is also great for accessories like front/rear mount cameras, aftermarket HID headlights, aftermarket Horns, etc. Accessories like this use the vehicles own internal system to activate the accessory but due to the thin gauge of wire used for OEM applications most new accessories have their own power input to draw from.
NOTE: none of these blue sea accessories are needed in order for the switch pros to operate. The Blue Seas products are independent from the switch pros and only aid in the organization of wires. Also Switch pros has now stated that their new SP-9100 unit should not be installed on a flat surface due to water pooling up on the surface of the unit and seeping in through the connector. If installed on a flat surface (like it does on this tray) you may void the manufacturers warranty if a failure happens as a result of water ingress.
All PowerTrays are Waterjet cut out of robust 1/8" Brushed Aluminum and perfectly bent to match the angle of the inner fender. PowerTrays achieves unparalleled stability utilizing three points of contact with the use of an additional support leg that secures the far side of the tray by bolting it down to the lower fender. Ships right to your front door with full color instructions. Designed, Made, and Shipped from Colorado.
- Switch-Pro/Blue Sea PowerTray
- Support Leg
- Hardware Bag
For all Blue Sea accessories, Cables, Hardware, and terminals needed for installation Click Here
Manual transmission models require the clutch fluid reservoir to be relocated to a special bracket installed on the underside of the PowerTray. Click Here for more info on the process.
Due to a change in the braking system on certain Tacoma models this version is made for TRD Off-Road/TRD Pro Tacoma models and will not fit SR, SR5, TRD Sport, and Limited models.